Make various adjustments of Saddle Stitcher SD-513.
Arrange the finishing of printouts by adjusting functions such as stapling, folding, and slitting.
Screen access
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment]
Setting item | Description |
---|---|
Adjust the pitch of the alignment plate for folding on the saddle stitcher to reduce misalignment and distortion in the paper stack during folding. | |
Adjust the push-in amount of the adjustment plates for the saddle stitcher. | |
Adjust the fold position on the saddle stitcher. | |
Adjust the tri-fold position on the saddle stitcher. | |
Adjust the crease position of Creaser Unit CR-101 mounted on Saddle Stitcher SD-513. | |
Adjust the pitch of the alignment plate for stapling on the saddle stitcher to reduce misalignment and distortion in the paper stack. | |
Adjust the center position when stapling on the saddle stitcher. | |
Adjust the staple pitch when stapling on the saddle stitcher. | |
Adjust the position when stapling on the saddle stitcher. | |
Change the staple pitch on the saddle stitcher, and adjust the staple tip form. | |
Adjust the strength when forming a booklet spine. | |
Adjust the number of back-and-forth motions of the roller when forming the spine of a Fold & Staple book. | |
Adjust the parallelism between the trimming line and the fore edge on the saddle stitcher. | |
Adjust the trimming width on the fore-edge side on the saddle stitcher. | |
Adjust the trimming width on the top and bottom sides of the saddle stitcher. | |
Adjust the trimmer receiver position on the saddle stitcher. |