[Parallel Trimming Adjustment]
Overview
Adjust the parallelism between the trimming line and the fore edge on the Saddle Stitcher SD-513.
Make this adjustment when there is a problem with the form of printouts.
NOTICE
The following option is required to use this function.
- Saddle Stitcher SD-513 with Folding Unit FD-504 mounted
Setting Procedure
1
Select [(1)Front] or [(2)Rear].
2
Press [Print Mode].
3
Load A3 w or 11 e 17 w paper into any paper tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check parallelism "a" of the trimming edge.
Standard value: a = 4.0 mm or less (Fold & Staple quantity: 50 sheets)
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:0~+30 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.