Home >
Adjustment > [Saddle Stitcher Adjustment] (Saddle Stitcher SD-513) > [Fold Paper Width Adj.]
[Fold Paper Width Adj.]
Overview
Adjust the pitch of the alignment plate for folding on Saddle Stitcher SD-513 to reduce misalignment and distortion in the paper stack during folding.
Make this adjustment when misalignment occurs on the paper stack for [Fold&Staple], [Multi Half], or [Multi 3-Fold].
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Setting Procedure
1
Press the selection key of the paper size to adjust.
3
Load the paper of the size to be adjusted into any tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check for misalignment in the paper stack.
a: If the setting value of the paper width is wider than the actual paper width, misalignment in the paper stack becomes uneven.
b: If the setting value of the paper width is narrower than the actual paper width, misalignment in the paper stack is in one direction (distortion).
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-50~+50 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.