[Flattening a Fold (Strength)]
Overview
Adjust the strength when forming a booklet spine.
Make this adjustment when there is a problem with the form of the spine.
Tips
- In this adjustment, set the reference value of the spine forming strength specified on the [COPY] screen or in the printer driver. If the strength specified on the [COPY] screen or in the printer driver is insufficient, you can specify a stronger strength in this adjustment, but be careful that the reference value shifts completely.
Setting Procedure
1
Press [Print Mode].
2
Load A3 w or 11 e 17 w paper into any paper tray, and select that paper tray.
3
Press Start on the Control panel.
A sample is output.
4
Check the spine of the output booklet.
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.