[Lead Edge Erase Adjustment]
Overview
Adjust the amount of the image loss on a lead edge (amount of the blank area in the original) when printing.
NOTICE
The following setting is required to use this function.
- Perform [FD-Mag. Adjustment] in [Printer Adjustment].
Reference
- For details about [FD-Mag. Adjustment], refer to [FD-Mag. Adjustment].
Setting Procedure
1
Press [Print Mode].
2
Set A3 w or 11 e 17 w paper and select the relevant paper feed tray.
3
Press Start on the Control panel to output a chart.
For details about the "
" mark that is printed on the front side of the chart, refer to About Charts.
4
Use the scale to measure the amount of the image loss on a lead edge (amount of the blank area in the original).
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+40 1step = 0.1mm]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.