[Pre-registration Adj.]
Overview
Adjust the amount of paper loop for pre-registered rollers such as paper trays.
Adjust if there is a paper jam in the register part or if paper curls or wrinkles has occurred.
Tips
[Pre-registration Adj.] is added to the adjustment values in [Paper Setting] - [Change Set] - [Expert Adj.] on [MACHINE] screen as shown below. However, the adjustment range of [Tray1] to [Tray9] and [Bypass] is 0 to +149 (1 step = 0.1 mm), and that of other items is -99 to +99 (1 step = 0.1 mm). Check the adjustment values in [Paper Setting] - [Change Set] - [Expert Adj.] on [MACHINE] screen if the adjustment is not successful.
- The adjustment values of [Tray1] to [Tray9] or of [Bypass] are added to the adjustment values for [Pre-regist. Loop Adj.(Front)] for each paper feed tray.
- The adjustment values of [1st PFU Connecting Part] and [2nd PFU Connecting Part] are added to the adjustment values for each of [Pre-regist.Loop:1st Connection] and [Pre-regist.Loop:2nd Connection].
Tips
[Pre-registration Adj.] allows you to make adjustments for each paper thickness or for envelopes by selecting [Tray1] to [Tray9] or [Bypass] when any of the options shown below is mounted.
- Paper Feeder Unit PF-712
- Paper Feeder Unit PF-713
- Paper Feeder Unit PF-812
- Paper Feeder Unit PF-712 with Multi Bypass Tray MB-511 mounted
- Paper Feeder Unit PF-812 with Multi Bypass Tray MB-511 mounted
Tips
[Pre-registration Adj.] allows you to make adjustments for each paper thickness by selecting [1st PFU Connecting Part] or [2nd PFU Connecting Part] when any of the options shown below is mounted.
- Paper Feeder Unit PF-712 connected in double or triple units
Setting Procedure
1
Press the key for the item to be adjusted.
2
Press [Print Mode].
3
Set A3 w or 11 e 17 w paper to the paper tray you want to adjust and then select that paper tray.
4
Press Start on the Control panel to output a chart.
For details about the "
" mark that is printed on the front side of the chart, refer to About Charts.
5
Check for paper curls or wrinkles.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
8
Repeat steps 1 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.