[PFU Registration Adj.]

Adjust the amount of paper loop for pre-registered rollers of [Tray1] to [Tray9] and [Bypass].

Adjust if there is a paper jam in the register part or if paper curls or wrinkles has occurred.

The adjustment is possible in the wider range than [Pre-registration Adj.].

NOTICE

One of the following options is required to use this function.

• Paper Feeder Unit PF-712
• Paper Feeder Unit PF-713
• Paper Feeder Unit PF-812
• Multi Bypass Tray MB-511

Reference

• For details about [Pre-registration Adj.], refer to [Pre-registration Adj.].

1

Select the target paper tray selection key and paper type.

2

Press [Print Mode].

3

Load A3 w or 11 e 17 w paper in the paper tray for adjustment selected in step 1, and select that paper tray.

4

Press Start on the Control panel.

• For details about the "" mark that is printed on the front side of the chart, refer to About Charts.

5

Check for paper curls or wrinkles.

6

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

7

Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.

• Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].

• [Adj. Range:0~+200 1step = 0.1mm]

8

Repeat steps 1 to 7 until the desired result is obtained.