Set the FTP server used as the destination when sending scan data with FTP.
This item is required to use Scan to FTP.
Setting item | Description | |
---|---|---|
[ON] | Uses the FTP sending function. | |
[OFF] | Does not use the FTP sending function. | |
[Proxy Server Address] - [Host Address] | [Input Host Name] | Set the host name of the proxy server that communicates with this system when performing FTP sending. Up to 253 single-byte characters can be entered, including periods. If entering 64 or more single-byte characters, it is necessary to separate them using periods (.). |
[IPv4 Address Input] | Enter the IPv4 address. Range: (0 to 255).(0 to 255).(0 to 255).(0 to 255) Default: 0.0.0.0 | |
[IPv6 Address Input] | Enter the IPv6 address. Range: 1 byte to 39 bytes Default: 0:0:0:0:0:0:0:0 | |
[Proxy Server Port Number] | Set the port number of the proxy server that communicates with this system when performing FTP sending. Enter the proxy server port number using the Keypad of the Control panel. Range: 1 to 65535 | |
[PASV Mode] | Configure settings to use the passive mode when performing FTP connection. | |
[Connection Timeout] | If the specified time period elapses without any operations being carried out while connected to the proxy server that communicates with this system for FTP sending, the connection is interrupted. Press [Input], and enter the timeout period using the Keypad on the Control panel. Range: 5 sec. to 300 sec. |