Adjust the trimming width on the fore-edge side on the Saddle Stitcher SD-513.
Make this adjustment when there is a problem with the printout finishing.
A sample is output.
Standard value: a = 5 mm or more
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-400~+400 1step = 0.1mm]
Set the trimming width so that the cover is trimmed by 5.0 mm or more. If the trimming width is below 5.0 mm, it may cause a trimming failure. Therefore, even if the value is set so that the trimming width is less than 5.0 mm, the trimming width is automatically controlled so that the actual trimming width is not less than 5.0 mm.