[Edit]
Overview
Set the protocol.
You can set the group name or protocol type for each group.
Reference
- For details about how to enter characters, refer to Entering Text.
Setting Items
Setting item | Description | |
|---|---|---|
[ON] | Uses the selected [Group] protocol settings. | |
[OFF] | Does not use the selected [Group] protocol settings. Also, if selected, the currently selected [Group] is deleted. | |
[Group Name] | Enter the group name used for the encrypted communication. Up to 10 single-byte characters can be entered. | |
[Protocol Identification Setting] | [TCP] | Set the protocol to TCP when performing IPsec communication. [Port Specification Method] is available. |
[UDP] | Set the protocol to UDP when performing IPsec communication. [Port Specification Method] is available. | |
[ICMP] | Set the protocol to ICMP when performing IPsec communication. | |
[ICMPv6] | Set the protocol to ICMPv6 when performing IPsec communication. | |
[Do Not Set] | Does not set protocol. | |
[Port Specification Method]* | [Port Number] | Set [Sender Port Number] and [Destination Port Number]. |
*: The following setting is required to use this function.
Set [Protocol Identification Setting] to [TCP] or [UDP].
Setting Procedure
Set [Port Specification Method].
1
Press [Input] of [Sender Port Number].
2
Enter the sender's port number using the Keypad on the Control panel.
3
Press [Input] on the [Sender Port Number].
4
Enter the port number using the Keypad of the Control panel.
5
Press [OK].
The setting is applied.
in the upper-right of a page, it turns into 
and is registered as a bookmark.