Home >
Adjustment > [Saddle Stitcher Adjustment] (Saddle Stitcher SD-513) > [Staple Paper Width Adj.]
[Staple Paper Width Adj.]
Overview
Adjust the pitch of the alignment plate for stapling on the Saddle Stitcher SD-513 to reduce misalignment and distortion in the paper stack.
Make this adjustment when misalignment or distortion occurs on the paper stack during stapling.
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Setting Procedure
1
Select the key of the paper size you want to adjust.
3
Load the paper of the size to be adjusted into any tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check for misalignment "a" and distortion "b" in the paper stack.
a: Misalignment occurs if the specified paper width is wider than the paper width.
b: A distortion occurs If the specified paper width is narrower than the actual paper width.
Standard value: a = 1 mm or less
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.