[Registration Loop Adj.]
Overview
Adjust the amount of paper loop of the registration roller.
Adjust if there is a paper jam in the register part or if paper curls or wrinkles has occurred.
Setting Procedure
1
Press the key for the item to be adjusted.
2
Press [Print Mode].
3
Set A3 w or 11 e 17 w paper to the paper tray you want to adjust and then select that paper tray.
4
Press Start on the Control panel to output a chart.
For details about the "
" mark that is printed on the front side of the chart, refer to About Charts.
5
Check for paper curls or wrinkles.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-99~+99 1step = 0.1mm]
8
Repeat steps 1 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.