[Density Balance Chart Output]

Output a density balance chart.

Measure the output density balance chart using a colorimeter and register the adjustment value.

NOTICE

• Outputs the chart to which the screen type set in this system is applied. Select an appropriate screen and paper type before outputting the chart. Go to Administrator Setting > Custom Screen to change the screen type.

Tips

• If [Density Balance Auto. Adj.] is performed without the scanner when Intelligent Quality Care Unit IQ-501 is not mounted, output the density balance chart, make measurements with a colorimeter, and register the adjustment value.
• Refer to the manual included with the colorimeter for more details regarding how to use the colorimeter and how to produce colorimetric data.

1

Select the colorimeter you want to use, and press [Print Mode].

2

Press [Quality Adj.].

3

Press [Screen Pattern].

• You can also press [)] on the right of [Screen Pattern] to switch the screen.

4

Select the screen to output, and press [OK].

5

Press [Close].

6

Select a paper tray loaded with paper of any of the following sizes: 12 e 18 w, SRA3 w, 13 e 19 w, 11 e 17 w or A3 w.

7

Press Start on the Control panel.

A chart is output.

8

Measure the output chart with a colorimeter and create colorimetric data.

9

Register colorimetric data to this system.

• When registering colorimetric data using a USB flash drive, refer to Setting Procedure (Registering Colorimetric Data of the USB Flash Drive in This System). When registering it via Web, refer to Setting Procedure (Registering Colorimetric Data in This System via Web).