[ON]

Allows the customer engineer to operate the remote panel.

[OFF]

Prohibits the customer engineer from carrying out remote panel operation.

[Port No.]

Set the port number used for communication with this system.

Press [Input], and enter it using the Keypad on the Control panel.

Range: 1 to 65535

[Connection timeout]

If the specified time period elapses without any operations being carried out during the connection with this system when using the remote panel, the connection is interrupted.

Press [Input], and enter it using the Keypad on the Control panel.

Range: 20 sec. to 300 sec.

[Server Address] - [Host Address]

[Input Host Name]

Set the host name of the proxy server address used for a communication with this system.

Up to 253 single-byte characters can be entered, including periods.

If entering 64 or more single-byte characters, it is necessary to separate them using periods (.).

[IPv4 Address Input]

Sets the IPv4 address.

Range: (0 to 255).(0 to 255).(0 to 255).(0 to 255)

[IPv6 Address Input]

Sets the IPv6 address.

Range: 1 byte to 39 bytes

[Certificate Verification Level Settings]

[Expiration Date]

Checks whether the certificate has expired when verifying the certificate during SSL communication.

[Key Usage]

Checks whether the certificate is used according to the intended usage approved by the issuer of the certificate.

[Chain]

Checks whether there are any problems in the certificate chain (certificate path). To confirm the chain, refer to the external certificate managed in the system.

[Expiration Date Confirmation]

Checks whether the certificate has expired.

[CN]

Checks whether the CN (Common Name) of the certificate matches the server address.

[Synchronize WebDAV Client Setting] - [Individual Settings]

[Proxy Server Address]

Enter the proxy server address.

Press [Input Host Name], [IPv4 Address Input], or [IPv6 Address Input] to switch the entry item.

[Proxy Server Port Number]

Enter the port number of the proxy server.

Range: 1 to 65535

[User Name]

Enter the user name.

Up to 63 single-byte characters can be entered.

[Password]

Enter the password.

Up to 63 single-byte characters can be entered.

[Launch Remote Panel from vCare]

Configure settings to allow the remote panel to be started from the remote diagnostic system.

When this item is enabled, the remote panel operation buttons are displayed in the Setting menu. For details, contact your service representative.