[Main Scan Dir. Zoom(Back)]
Overview
Adjust the magnification in the main scanning direction (crosswise direction) of the back side when using the ADF.
Scanning accuracy is maintained by making regular adjustments.
NOTICE
To make correct adjustments, configure the following setting in advance.
- Perform [CD-Mag. Adjustment] in [Printer Adjustment].
Reference
- For details about [CD-Mag. Adjustment] in [Printer Adjustment], refer to [CD-Mag. Adjustment].
Setting Procedure
1
Press [Print Mode].
2
Load A4 paper into any paper tray, and select that paper tray.
3
Load a test chart into the ADF tray with the back side facing up, and press Start on the Control panel.
The test chart is scanned and a sample is printed out.
4
Measure the width in the crosswise direction, and compare the measured value with the chart.
Standard value: 0 mm ^ 1.4 mm
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-10~+10 1step = 0.1%]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.