Home >
Adjustment > [Saddle Stitcher Adjustment] (Saddle Stitcher SD-513) > [Crease Position Adjustment] > [Tri-Fold Crease Position]
[Tri-Fold Crease Position]
Overview
Adjust the tri-fold crease position of Creaser Unit CR-101 mounted on Saddle Stitcher SD-513.
Make this adjustment when the distance from the paper edge to the crease position deviates from the standard value at both the [Fold 1] crease position and [Fold 2] crease position.
To make correct adjustments, configure the following setting in advance.
- Perform [Tri-Fold Position Adj.] in [Saddle Stitcher Adjustment].
- Once the crease position is adjusted, the fold position may not match the crease position depending on the paper weight. In this case, make this adjustment again so that the fold position matches the crease position.
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Setting Procedure
1
Press the selection key of the paper size to adjust.
3
Load the paper of the size to be adjusted into any tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check the misalignment of "a" between the folding line of the output paper and the crease part.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
8
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
Adjust the length from the inside edge to the Fold 1 crease position.
10
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
Adjust the length from the inside edge to the Fold 2 crease position.
11
Repeat steps 2 to 10 until the desired result is obtained.