[Banner Skew Adjustment]
Overview
Adjust a skew amount of a steering roller.
Setting Procedure
1
Press the selection key of the steering roller to adjust.
2
Press [Print Mode].
3
Load the desired paper into a paper tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check a skew of the output paper.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To slow down the roller, (+) To speed up the roller
[Adj. Range:0~+50 1step = 0.1%]
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.