[Staple Position Adjustment]
Overview
Adjust the staple pitch between 2 staple positions and the staple position of the corner staple.
Make this adjustment when finishing the print paper.
Setting Procedure
1
Select the staple position to adjust.
2
Press [Print Mode].
3
Load the desired paper into a paper tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check staple positions "a" of the sheets that are output to the Main tray.
Standard value
1: 2-position pitch = -3 mm to +3 mm
2: [Rear Diagonal] -3 mm to +3 mm
3: [Rear Parallel] -3 mm to +3 mm
4: [Front Parallel] -3 mm to +3 mm
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
2-position pitch / [Rear Diagonal]: [Adj. Range:-5~+5 1step = 1mm]
[Rear Parallel] / [Front Parallel]: [Adj. Range:-3~+3 1step = 1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.