[CD Alignment Adjustment]
Overview
Adjust the alignment amount in the crosswise direction of Trimmer Unit TU-510.
NOTICE
The following option is required to use this function.
- Trimmer Unit TU-510 with Banner Unit MK-764 mounted
Tips
- This is a setting item used to adjust a skew on banner paper. When cutting business cards using standard size paper, you can also adjust a skew by changing the setting of [Banner CD Alignment 5].
Setting Procedure
1
Press the target alignment position selection key.
2
Press [Print Mode].
3
Load the desired paper into a paper tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check the distortion or skew of the post-processing position.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To decrease the push-in amount of the alignment plate, (+) To increase the push-in amount of the alignment plate
[Adj. Range:-30~+30 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.