[CD-Mag. Adjustment]

Adjust the magnification in the crosswise direction when scanning the original using the Original glass.

Using this function allows you to vary the magnification of an image and adjust so that the image is correctly magnified.

NOTICE

The following setting is required to use this function.

• Perform [CD-Mag. Adjustment] in [Printer Adjustment].

Reference

• For details about [CD-Mag. Adjustment] in [Printer Adjustment], refer to [CD-Mag. Adjustment].

1

Press [Print Mode].

2

Load A3 w or 11 e 17 w paper into any paper tray, and select that paper tray.

3

Place a test chart on the Original glass, and press Start on the Control panel.

A test chart is copied.

4

Measure the width in the crosswise direction, and compare the measured value with the chart.

• Standard value: 0% ^ 0.5% or less (full size)

• Example: Within 200 mm ^ 1 mm

5

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

6

Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.

• Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].

• [Adj. Range:990~1010 1step = e0.001]

7

Repeat steps 1 to 6 until the desired result is obtained.