[Registration Adjustment]
Overview
Adjust the amount of paper loop of the registration roller, and straighten the bends and wrinkles of the paper.
Perform this function when the punch position is tilted.
Setting Procedure
1
Press [Print Mode].
2
Load the desired paper into a paper tray, and select that paper tray.
[Output Setting] is automatically set to [Punch].
3
Press Start on the Control panel.
A sample is output.
4
Check the inclination of the punch position.
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-50~+50 1step = 0.1mm]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.