Adjust the fold position for SaddleStitcher SD-506.
Make this adjustment when the fold position deviates from the standard value.
For SaddleStitcher SD-506, when [Fold&Staple] or [Multi Half] is selected to output a sample, always pull out the Fold/Staple mode tray before printing. Otherwise, a sample is not output even if you press Start on the Control panel.
Standard value: a = 1.5 mm or less
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-50~+50 1step = 0.1mm]