[Clamp FD Position Adj.]

Adjust the alignment width in the fore-edge direction (paper feed direction) of the body in the clamp section.

Make this adjustment when misalignment or distortion occurs in the fore-edge direction of the body during perfect binding using Perfect Binder PB-503.

Tips

• If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].

1

Load covers into the Perfect binder cover tray or any paper tray.

• When using any paper tray, you need to set a cover tray by selecting [Perfect Bind] of [Output Setting]. For details, refer to [Cover Tray].

2

Load body paper into any paper tray.

3

Select the key of the paper size you want to adjust.

4

Press [Print Mode].

5

Select the tray in which body paper was loaded in step 2.

6

Press Start on the Control panel.

A perfect binding sample is output.

7

Check whether the sub scanning direction of the body is unified on all pages.

8

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

9

Use the on-screen keypad to enter the numeric value.

• Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].

• (-) To reduce the distortion, (+) To reduce the misalignment

• [Adj. Range:-20~+20 1step = 0.1mm]

10

Repeat steps 4 to 9 until the desired result is obtained.