[2 Position Staple]

Adjust the center position when performing the 2-position staple on the Saddle Stitcher SD-513.

Make this adjustment when the staple position deviates from the standard value.

NOTICE

To make correct adjustments, configure the following setting in advance.

• Perform [Half-Fold Position Adj.] in [Saddle Stitcher Adjustment].

Reference

• For details about [Half-Fold Position Adj.] in [Saddle Stitcher Adjustment], refer to [Half-Fold Position Adj.].

1

Press [Print Mode].

2

Load A3 w or 11 e 17 w paper into any paper tray, and select that paper tray.

3

Press Start on the Control panel.

A sample is output.

4

Check the misalignment between the staple center position and paper center position.

5

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

6

Use the on-screen keypad to enter the numeric value.

• Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].

• [Adj. Range:-20~+20 1step = 0.1mm]

7

Repeat steps 1 to 6 until the desired result is obtained.