[FD-Mag. Adjustment]
Overview
Adjust the magnification in the paper feed direction when using the ADF.
Scanning accuracy is maintained by making regular adjustments.
NOTICE
To make correct adjustments, configure the following setting in advance.
- Perform [FD-Mag. Adjustment] in [Printer Adjustment].
Reference
- For details about [FD-Mag. Adjustment] in [Printer Adjustment], refer to [FD-Mag. Adjustment].
Setting Procedure
1
Press [Print Mode].
2
Load A4 paper into the paper tray, and select that paper tray.
3
Load a test chart into the ADF tray with the front side facing up, and press Start on the Control panel.
The test chart is scanned and a sample is printed out.
4
Measure the length in the paper feed direction, and compare the measured value with the chart.
Standard value: 0 mm ^ 1.0 mm
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1%]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.