[Half-Fold Fold Position Adj.]

Adjust the half-fold position for Multi Half-Fold.

Make this adjustment when the half-fold position for Multi Half-Fold deviates from the standard value.

Tips

• If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].

1

Press the selection key of the paper size to adjust.

2

Press [Print Mode].

3

Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.

• [Output Setting] is automatically set to [Multi Half].

4

Press Start on the Control panel.

A sample is output.

5

Check the misalignment of "a" at the edge of the output paper.

• Standard value: a = 1 mm or less

6

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

7

Use the on-screen keypad to enter the numeric value.

• Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].

• [Adj. Range:-50~+50 1step = 0.1mm]

8

Repeat steps 2 to 7 until the desired result is obtained.