Adjust the alignment plate position in the paper feed direction of the Relay Unit RU-510 to eliminate misalignment of punch holes.
This function is available when paper is conveyed while the position of the paper feed direction is not fixed against the next-stage finisher.
A sample is output. This section describes a sample with punch holes.
If punch holes are misaligned in the paper feed direction, adjust the FD alignment plate position.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[-] To reduce the dispersion, [+] To reduce the misalignment
[Adj. Range:-50~+50 1step = 0.1mm]
To make adjustments, set the paper length adjustment value to the maximum (to reduce misalignment), adjust in the direction to reduce dispersion , and find a point at which the through hole of the punch holes is not misaligned.