Home >
Adjustment > [Saddle Stitcher Adjustment] (Saddle Stitcher SD-513) > [Staple Center Position] > [4 Position Staple(Rear 2)]
[4 Position Staple(Rear 2)]
Overview
Adjust the center position when performing the 4-position staple on the Saddle Stitcher SD-513.
Make this adjustment when the staple position deviates from the standard value.
This function adjusts the 2 rear locations of the 4 staple positions.
To make correct adjustments, configure the following setting in advance.
- Perform [Half-Fold Position Adj.] in [Saddle Stitcher Adjustment].
Setting Procedure
1
Press the selection key of the paper size to adjust.
3
Load the paper of the size to be adjusted into any tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check the length from the edge to the center of the 2 rear locations of the 4 staples for the paper size.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-100~+100 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.