Adjust the pitch of the alignment plate for folding on SaddleStitcher SD-506 to reduce misalignment and distortion in the paper stack during folding.
Make this adjustment when misalignment occurs on the paper stack for [Fold&Staple], [Multi Half], or [Multi 3-Fold].
When [Fold&Staple] or [Multi Half] is selected to output a sample, pull out the Fold/Staple mode tray. Otherwise, a sample is not output even if you press Start on the Control panel. Before printing, always pull out the tray.
a: If the setting value of the paper width is wider than the actual paper width, misalignment in the paper stack becomes uneven.
b: If the setting value of the paper width is narrower than the actual paper width, misalignment in the paper stack is in one direction (distortion).
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-50~+50 1step = 0.1mm]