[Spine Corner Forming Pos.]
Overview
Adjust the spine form.
When binding with Perfect Binder PB-503, you can set whether the spine is square or rounded by adjusting the amount of force applied when forming the spine.
Setting Procedure
1
Load covers into the Perfect binder cover tray or any paper tray.
When using any paper tray, you need to set a cover tray by selecting [Perfect Bind] of [Output Setting]. For details, refer to [Cover Tray].
2
Load body paper into any paper tray.
3
Select [Up/Down Forward Adj.] or [Up/Down Rear Adj.].
4
Press [Print Mode].
5
Select the tray in which body paper was loaded in step 2.
6
Press Start on the Control panel.
A perfect binding sample is output.
7
Check whether the spine of the output perfect binding book is formed uniformly in relation to the scanning direction.
(1) Left cover (2) Spine (3) Right cover (4) Scanning direction
8
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
9
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To convex (+) To concave
[Adj. Range:-128~+127 1step = 0.1mm]
10
Repeat steps 4 to 9 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.