[Z-Fold Position Adj.]
Overview
Adjust the fold positions for Z-folding of the FoldingUnit FD-503. Make this adjustment when the fold position deviates from the standard value.
Tips
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
- When adjusting both [Fold 1] and [Fold 2], first adjust [Fold 1].
Confirm the following standard values in step 5.
Paper size | Standard value a | Standard value b |
|---|---|---|
[A3w] | 105.5 mm | 108.5 mm |
[B4w] | 91.5 mm | 94.5 mm |
[SRA4w] | 80.5 mm | 83.5 mm |
[A4w] | 74.8 mm | 77.8 mm |
[12e18w] | 114.8 mm | 117.8 mm |
[11e17w] | 108.5 mm | 111.5 mm |
[8.5e14w] | 94.0 mm | - |
[8.5e11w] | 70.4 mm | 73.4 mm |
[8Kw] | 98.0 mm | 101.0 mm |
Setting Procedure
1
Press the selection key of the paper size to adjust.
2
Press [Print Mode].
3
Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.
[Separate Scan] is automatically set to [Z-Fold].
4
Press Start on the Control panel.
A sample is output.
5
Check lengths "a" and "b" of the printed paper.
Standard value: a, b = -1.5 mm to +1.5 mm or less
(1) [Fold 1], (2) [Fold 2]
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Select [Fold 1].
8
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-50~+50 1step = 0.1mm]
9
Select [Fold 2].
10
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-50~+50 1step = 0.1mm]
11
Repeat steps 2 to 10 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.