[Cover Up/Down CD Width Adj.]
Overview
Adjust the alignment width of the top and bottom sides of the cover.
Make this adjustment when there is a problem with the cover position when performing perfect binding using Perfect Binder PB-503.
Setting Procedure
1
Load covers into the Perfect binder cover tray or any paper tray.
When using any paper tray, you need to set a cover tray by selecting [Perfect Bind] of [Output Setting]. For details, refer to [Cover Tray].
2
Load body paper into any paper tray.
3
Select [Perfect Binder Tray], or select [Except PB Tray] if you selected any paper tray in step 1.
4
Press [Print Mode].
5
Select the tray in which body paper was loaded in step 2.
6
Press Start on the Control panel.
A perfect binding sample is output.
7
Check that no misalignment, protrusion, or distortion occurs between the body and cover.
8
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
9
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To reduce the distortion (+) To reduce the misalignment
[Adj. Range:-20~+20 1step = 0.1mm]
10
Repeat steps 4 to 9 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.