Adjust the loop amount of the registration roller section in the staple finisher when feeding paper from the PostInserter PI-502.
Perform this adjustment when problems such as bending or wrinkling of the paper, or paper jams occur.
[PI Upper Tray]: Exit the [Adjustment] menu once, and follow the normal printing procedure to output a job that is fed from the Upper tray.
[PI Lower Tray]: Select any output mode on the Control panel of PostInserter PI-502, and press Start/Stop button.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-5~+5 1step = 1mm]