[Paper Skew Adjustment]
Overview
Adjust a skew in the paper feed direction.
Setting Procedure
1
Press the selection key of the paper weight to adjust.
2
Select [Coated] or [Uncoated].
These items are not selectable when [Offset for All] is selected in step 1.
3
Press [Print Mode].
4
Load the paper selected in steps 1 and 2 into any paper tray, and select that paper tray.
5
Press Start on the Control panel.
A sample is output.
6
Check a skew of the output paper.
7
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
8
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-125~+125 1step = 0.02%]
The adjustment value can be calculated as follows: Amount of paper distortion (a) รท Length in main scanning direction (crosswise direction) at paper edge (b).
9
Repeat steps 3 to 8 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.