[Standby Pos.(Rear Adj.)]

Adjust the alignment plate position in the back of the crosswise direction of the Stacker tray to eliminate misalignment or distortion of the output paper.

This function is available when a significant misalignment occurs in the crosswise direction during output processing.

Tips

• Make adjustments together with [Standby Pos.(Front Adj.)]. For details about [Standby Pos.(Front Adj.)], refer to [Standby Pos.(Front Adj.)].

1

Select the stacker tray to adjust the alignment plate.

2

Press the selection key of the paper size to adjust.

3

Press [Print Mode].

4

Load the desired paper into a paper tray, and select that paper tray.

5

Press Start on the Control panel.

A sample is output, and printing is interrupted. A warning message is displayed on the screen.

6

Check whether the distance between the paper edge in Large Capacity Stacker LS-507 and the alignment plate position in the back of the crosswise direction is 5 mm.

When the check is completed, remove paper.

7

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

8

Use the on-screen keypad to enter the numeric value.

• Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].

• (-) To narrow the standby position, (+) To widen the standby position

• [Adj. Range:-20~+20 1step = 0.1mm]

9

Repeat steps 3 to 8 until the desired result is obtained.