[2-Hole Punch]
Overview
Adjust the interval between 2 punch holes and the paper edge on the FoldingUnit FD-503. Perform this function when the punch holes are very misaligned.
Tips
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Setting Procedure
1
Press the selection key of the paper size to adjust.
2
Press [Print Mode].
3
Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check distance "a" to the center of punch holes on the output paper.
Standard value: 10.5 mm -4.0 mm to +4.0 mm
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-40~+40 1step = 0.1mm]
Adjust the setting value by referencing the figure.
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.