[Fold&Staple Pitch Adjustment]
Overview
Adjust the staple pitch when stapling for Fold & Staple.
Make this adjustment when misalignment or distortion occurs on the paper stack during stapling.
Tips
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Setting Procedure
1
Press the selection key of the paper size to adjust.
2
Press [Print Mode].
3
Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.
[Output Setting] is automatically set to [Fold&Staple].
4
Press Start on the Control panel.
A sample is output.
5
Check for staple pitch "a" relative to paper size "b".
Standard value: a = b /2 -3 mm to +3 mm or less
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-300~+300 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.