HomeDescriptions of Functions / Utility KeysHorizontal Punch (Z-Fold) Position Adjustment

Horizontal Punch (Z-Fold) Position Adjustment

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Horizontal Punch (Z-Fold) Position Adjustment]

If the positions of the punch holes on the paper are displaced sideways, use this option to adjust the punch hole positions.

Copy after configuration, then repeat adjustments as required.

Settings

Description

[-]/[+]

Enter an adjustment value between -5.0 and 5.0 mm by tapping [-] and [+].

  • [-]: Move the punch position to the left.

  • [+]: Move the punch position to the right.

[0.0 mm] is specified by default.

  • This adjustment is possible when the Finisher FS-535 and Z Folding Unit ZU-606 are installed in bizhub C554e.

  • Make adjustment while checking a sheet of paper having punched holes that are not in the correct positions.