HomeDescriptions of Functions / Utility KeysSNMP Settings

SNMP Settings

To display:
  • [Utility]
    • [Administrator Settings]
      • [Network Settings]
        • [SNMP Settings]

Configure the settings to obtain information of this machine or to monitor the machine using Simple Network Management Protocol (SNMP).

Settings

Description

[ON]/[OFF]

Select whether to use SNMP.

[ON] is specified by default.

[SNMP v1/v2c(IP)]

Select whether to use SNMP v1 or SNMP v2.

[ON] is specified by default.

[SNMP v3(IP)]

Select whether to use SNMP v3.

[ON] is specified by default.

[SNMP v1(IPX)]

Select whether to use SNMP v1 in the IPX environment.

[ON] is specified by default.

[UDP Port Number]

If necessary, change the UDP port number.

Normally, you can use the original port number.

[161] is specified by default.

[SNMP v1/v2c Settings]

Tap [SNMP v1/v2c Settings] to configure SNMP v1 or v2c settings.

  • [Read Community Name Settings]: Enter a read-only community name (using up to 15 characters). [public] is specified by default.

  • [Write Setting]: Select whether to enable the read and write functions. [Enable] is specified by default.

  • [Write Community Name Settings]: If [Write Setting] is set to [Enable], enter the community name in the read-write enable state (using up to 15 characters). [private] is specified by default.

[SNMP v3 Settings]

Tap [SNMP v3 Settings] to configure SNMP v3 settings.

  • [Context Name Settings]: Enter the context name (using up to 63 characters).

  • [Discovery User Permissions]: Select whether to allow a discovery user. [ON] is specified by default.

  • [Discovery User Name Settings]: If [Discovery User Permissions] is set to [ON], enter the discovery user name (using up to 32 characters). [public] is specified by default.

  • [Read User Name Settings]: Enter the read-only user name (using up to 32 characters). [initial] is specified by default.

  • [Security Level]: Select a security level for the read-only user. [auth-password/priv-password] is specified by default.

  • [Write User Name Settings]: Enter the user name of the user in the read-write enable state (using up to 32 characters). [restrict] is specified by default.

  • [Security Level]: Select a security level of the user in the read-write enable state. [auth-password/priv-password] is specified by default.

  • [Password Setting]: Enter the authentication password and privacy password of users in the read-only state and read-write enable state.

  • [Encryption Algorithm]: Select an encryption algorithm. [DES] is specified by default.

  • [Authentication Algorithm]: Select an authentication algorithm. [MD5] is specified by default.

[TRAP Setting]

Select whether to allow a notification of the status of this machine using the SNMP TRAP function.

[Allow] is specified by default.

[TRAP Setting When Authentication Failed]

Select whether to send TRAP when authentication fails.

[Invalid] is specified by default.