HomeDescriptions of Functions / Utility KeysPunch Regist Loop Size Adjustment

Punch Regist Loop Size Adjustment

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Punch Regist Loop Size Adjustment]

If the positions of the punch holes on the paper are not in parallel with the paper edge, use this option to correct the obliquity of the paper to make them parallel.

In bizhub C554e: This adjustment is possible when the Finisher FS-535 is installed.

Settings

Description

[Finisher]/[Finisher (Z-Fold)]/[Post Inserter Feeder Upper Tray]/[Post Inserter Feeder Lower Tray]

Select the position subject to paper inclination adjustment.

  • [Finisher]: This adjustment is possible when the Punch Kit PK-521 is installed.

  • [Finisher (Z-Fold)]: This adjustment is possible when the Z Folding Unit ZU-606 is installed.

  • [Post Inserter Feeder Upper Tray]: This adjustment is possible when the Punch Kit PK-521 and Post Inserter are installed.

  • [Post Inserter Feeder Lower Tray]: This adjustment is possible when the Punch Kit PK-521 and Post Inserter are installed.

[Paper Type]

Select the type of paper that is used to adjust the inclination.

[Adjust Value]

Enter an adjustment value by tapping [-] and [+].

  • [+]: Tap this button to adjust the inclination of the paper.

  • [-]: Tap this button if it is not possible to adjust the inclination with [+] or paper creases.

The available adjustment value is between -5.0 mm and 5.0 mm (other than [Finisher (Z-Fold)]) or between -16.0 mm and 16.0 mm ([Finisher (Z-Fold)]).

[0.0 mm] is specified by default.

This adjustment is possible when the Finisher FS-534 and Punch Kit PK-520, or the Finisher FS-533 and Punch Kit PK-519 are installed.

Settings

Description

[Paper Type]

Select the type of paper that is used to adjust the inclination.

[Adjust Value]

Enter an adjustment value between -4 and 4 by tapping [-] and [+].

  • [+]: Tap this button to adjust the inclination of the paper.

  • [-]: Tap this button if it is not possible to adjust the inclination with [+] or paper creases.

[0] is specified by default.

  • Make adjustment while checking a sheet of paper having punched holes that are not in the correct positions.