HomeDescriptions of Functions / Utility KeysPC-Fax RX Setting

PC-Fax RX Setting

To display:
  • [Utility]
    • [Administrator Settings]
      • [Fax Settings]
        • [Function Settings]
          • [PC-Fax RX Setting]

Configure the settings for using the PC-Fax RX function.

PC-Fax RX is a function that automatically saves a received fax to the Compulsory Memory RX User Box or a user box specified in F-Code (SUB Address). A stored fax job can be read from the user box into a computer.

Settings

Description

[Allow]/[Dial-In only]/[Restrict]

Select whether to use the PC-Fax RX function.

If the Dial In function is available, you can select [Dial-In only]. Selecting [Dial-In only] allows you to configure a setting so that PC-Fax RX is carried out only when a fax is received with a dial-in PC-FAX number.

[Restrict] is specified by default.

[Receiving User Box Destination]

Select either [Memory RX User Box] or [Specified User Box] (a User Box specified in F-Code (SUB Address)) as the location to save received faxes.

[Print]

Select whether to print a received fax after it has been received.

[OFF] is specified by default.

[Password Check]

If you select [Specified User Box] for [Receiving User Box Destination], specify whether to check the communication password (Sender ID) for PC-Fax reception.

If [ON] is selected, enter the requested password (a number containing up to eight digits).

  • If [Administrator Settings] - [Fax Settings] - [TX/RX Settings] - [Individual Receiving Line Setup] is set to [ON] while multiple lines are used, you can specify whether to use the PC-Fax RX function for each line.