HomeDescriptions of Functions / Utility KeysVertical Punch (Z-Fold) Position Adjustment

Vertical Punch (Z-Fold) Position Adjustment

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Vertical Punch (Z-Fold) Position Adjustment]

If the positions of the punch holes on the paper are displaced vertically, use this option to adjust the punch hole positions.

Copy after configuration, then repeat adjustments as required.

Settings

Description

[Paper Size]

Select the size of paper subject to punch hole position adjustment.

[Adjust Value]

Enter an adjustment value between -5.0 and 5.0 mm by tapping [-] and [+].

  • [-]: Move the punch position downward.

  • [+]: Move the punch position upward.

[0.0 mm] is specified by default.

  • This adjustment is possible when the Finisher FS-535 and Z Folding Unit ZU-606 are installed in bizhub C554e.

  • Make adjustments while checking paper punched at a displaced position.

  • The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.