HomeDescriptions of Functions / Utility KeysPunch Horizontal Position Adjustment

Punch Horizontal Position Adjustment

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Punch Horizontal Position Adjustment]

If the positions of the punch holes on the paper are displaced sideways, use this option to adjust the punch hole positions.

Copy after configuration, then repeat adjustments as required.

In bizhub C554e: This adjustment is possible when the Finisher FS-535 and Punch Kit PK-521 are installed.

Settings

Description

[Finisher]/[Post Inserter]

Select the position subject to punch hole position adjustment.

  • [Post Inserter]: This adjustment is possible when the Post Inserter is installed.

[Adjust Value]

Enter an adjustment value between -5.0 and 5.0 mm by tapping [-] and [+].

  • [-]: Move the punch position to the left.

  • [+]: Move the punch position to the right.

[0.0 mm] is specified by default.

This adjustment is possible when the Finisher FS-534 and Punch Kit PK-520 are installed.

Settings

Description

[Paper Type]

Select the type of paper subject to punch hole position adjustment.

[Adjust Value]

Enter an adjustment value between -10 and 10 by tapping [-] and [+].

  • [-]: Move the punch position to the left.

  • [+]: Move the punch position to the right.

[0] is specified by default.

  • Make adjustment while checking a sheet of paper having punched holes that are not in the correct positions.