Cleaning the Saddle Stitcher SD-513
Overview
Clean the Conveyance belt of Bundle exit tray in the Saddle Stitcher SD-513.
If the Conveyance belt is dirty, dirt may adhere to the output paper.
We recommend that you clean the tray each time you use it. Also, if Conveyance belt becomes dirty during use, clean it immediately.
Procedure
1
Open the Clamp section upper door.
You cannot open the Clamp section upper door while the saddle stitcher is idling. Open it after idling is completed.
2
Soak a soft cloth with cleaning alcohol, and wipe the visible parts of two Conveyance belt.
3
Move the Conveyance belt to clean the entire Conveyance belt.
Lightly lift two Conveyance belt with both hands, and at the same time pull them to the left to expose the uncleaned parts.
Wipe off the dirt on the Conveyance belt using a soft cloth soaked in cleaning alcohol.
You can clean the entire circumference of each belt by repeating steps 2 to 3 about 3 times.
NOTICE
- Do not pull the Conveyance belt while the saddle stitcher is idling. Forcibly pulling it may cause a machine failure. When pulling the conveyor belt, be sure to open the Clamp section upper door after the saddle stitcher has finished idling.
- Do not lift the Conveyance belt more than necessary. Also, when pulling out the belts, pull out two belts at the same time. Pulling out only one of them may cause the machine to malfunction.
4
Clean the bottom of the Bundle exit tray.
Wipe the entire bottom surface with a soft cloth soaked in cleaning alcohol.
5
Close the Clamp section upper door.
in the upper-right of a page, it turns into 
and is registered as a bookmark.