Load tab paper into the Paper Feed Unit PF-707m.
Side auxiliary guides are required for loading the tab paper. Load them into either the upper, middle or lower tray.
Example: Insert 3 sheets of tab paper into 3 print sets (total 9 sheets)
Tray Loading Direction | How to Stack the Tab Paper | Print Set |
---|---|---|
A: Back side B: Front side | A: Side printed or to be printed B: 1st tab paper C: 2nd tab paper D: 3rd tab paper | A: 1st tab paper B: 2nd tab paper C: 3rd tab paper D: 3-copy print set |
Any remaining paper which has not been printed can be automatically ejected from a set of tab paper loaded into the tray.
For example, when loading a single set of 5 papers (5 sheets of tab paper) and only three sheets are used, the remaining sheets will be ejected as shown in the figure below.
Original | Paper | Output | |
---|---|---|---|
Prints three sheets of tab paper | Sheets four and five of the tab paper are ejected automatically | ||
If the positioning screws are not attached, contact your service representative.
Attach the guides so that mark A is directed as shown in the figure.
Do not move the Paper holding plate fixing lever (2 locations) from the position on the Rear guide plate side. Moving it towards you may alter paper feed performance.
Pull out the tray for which tab paper is set.
A: Back side, B: Front side