Home >
Startup Guide > Paper Loading and Settings > Loading Paper > Loading Paper Into the Large Capacity Unit LU-202m
Loading Paper Into the Large Capacity Unit LU-202m
Overview
Load paper into the Large Capacity Unit LU-202m.
When loading paper of different specifications, change the paper setting of the large capacity unit.
For details about the paper setting, refer to [Paper Setting].
- If the machine is not powered on, the Tray bottom plate will not work. Turn the Sub power switch on. For details, refer to Turning This System On.
- If the Paper Feed Unit PF-707m is also mounted, it is recommended that the Paper Feed Unit PF-707m be used to feed the coated paper.
If any failures in the paper feed occur due to the type, size or weight of the paper being used, as shown in the figure below, attaching the provided weights to the pick-up roller may help improve the paper feed performance. Adjust by changing the number of weights.
Procedure
1
Open the Top door.
The Tray bottom plate goes down.
Proceed to Step 8 when loading paper of the same size.
Proceed to Step 2 when loading the paper of different sizes.
2
Rotate the Side guide knobs (4 locations) of the Side guides counterclockwise and loosen them.
3
Move the two Side guides according to the Paper size indicator on the top of the guide plate.
4
Rotate the Side guide knobs (applicable 2 locations) of the Side guides clockwise and lock them.
5
Rotate the Rear guide knob (2 locations) of the Rear guide counterclockwise and loosen them.
6
Move the Rear guide according to the Paper size indicator on the Tray bottom plate.
7
Rotate the Rear guide knob (2 locations) of the Rear guide clockwise and lock them.
8
Load the paper with the print side facing up.
9
Press the Tray bottom plate lowering button.
- If the machine is not powered on, the tray will not work even when you press the Tray bottom plate lowering button.
10
Repeat Steps 8 and 9 until the tray no longer descends.
- Exercise care not to exceed the maximum stack height lines displayed on the Side guides when loading the paper.
- Check that the Rear guide are aligned to the loaded paper. If there is a gap between the Rear guide and paper or the gap is too narrow, it may lead to paper jams and malfunctions.
11
Close the Top door.
The remaining paper amount indicator changes from "" to "".