Replacing the Toner bottle
Overview
When replacing the Toner bottle, check the toner type number displayed on the front surface of the toner bottle replenishing mouth and use a Toner bottle with the same number. Using a different Toner bottle can result in malfunction.
Reuse the cover supplied with the new Toner bottle to the used Toner bottle, and put it in the packing box. For details about what to do next, contact your service representative.
Tips
- You can count the number of times the Toner bottle has been replaced. For details, contact your service representative.
Safety Precautions
| |
|---|---|
Do not throw toner or a container that contains toner (e.g., toner cartridge, developing unit and Waste Toner Box) into an open flame. |  |
Warning
| |
|---|---|
Do not leave toner-related parts (e.g., toner cartridge, developing unit and Waste Toner Box) within easy reach of children. Licking any of these parts or ingesting toner could damage your health. |  |
Do not store toner-related parts (e.g., toner cartridge, developing unit and Waste Toner Box) near devices susceptible to magnetism, such as precision equipment and data storage devices, otherwise they may malfunction. They could cause these products to malfunction. | |
Do not force open the toner-related parts (e.g., toner cartridge, developing unit and Waste Toner Box). If toner tumbles from the toner bottle, take utmost care to avoid inhaling it or even getting skin contact. | |
If toner lands on your skin or clothing, wash thoroughly with soap and water. |  |
If you inhale toner, move to a place with fresh air and gargle with a lot of water repeatedly. Should you get symptoms such as coughing, seek medical advice. | |
If you get toner into your eyes, immediately rinse them with running water for over 15 minutes. Seek medical advice if irritation persists. | |
If you swallow toner, rinse out your mouth and drink a few glasses of water. Seek medical advice if necessary. | |
If you clean up toner, wear personal protective equipment. Vacuum or sweep material and place in a bag and hold for waste disposal. Use vacuum equipped with High Efficiency Particulate Air (HEPA) filter. Vacuum should be electrically bonded and grounded to dispel static electricity. To avoid dust generation, do not sweep dry. | |
Procedure
1
Press the key for the toner you want to replace in [Consumable and Scrap Indicators] ([Toner Y], [Toner M], [Toner C] or [Toner K]).
2
Press [,] or [+] to display the procedure, and then confirm it to perform processing accordingly.
For details about how to display the procedure, refer to Replenishing/Disposal Method Help Messages.
NOTICE
- When attaching the Toner bottle, push in the Toner bottle until it clicks into place. If the Toner bottle is not completely attached, it may cause a failure.
in the upper-right of a page, it turns into 
and is registered as a bookmark.