Paper Management
Overview
This system processes a large amount of paper at high speed. Therefore, a large amount of paper can be wasted if problems occur during paper feeding.
We recommend that you manage your paper on a regular basis by following the steps below.
NOTICE
- When checking the paper, be careful not to fold or scratch the paper.
Problematic Paper
Paper in the following conditions may not print correctly, so check and remove such paper.
Folded paper |  |
Curled corners |  |
Stuck-on glue |  |
Paper folded along entire edge of paper |  |
Procedure
1
Place the paper package on a flat surface and open it.
2
Check that the paper is not folded or scratched. If there are any such issues, remove that paper.
3
Also check the front and back of the paper.
It is recommended that you check the paper by lifting the stack as shown in the figure here.
4
Check that the individual sheets of paper are not stuck together due to static charge.
Lift up some of the top papers by about 1 cm and check where there is no crackling sound.
Any such sound indicates that it is charged with static electricity. It is recommended that you do not use paper such paper.
5
Press down the paper with your hand as shown in the figures and flick both edges of the paper in the direction the paper will be fed.
Place the paper on a flat surface when flicking through the paper. If you try flicking through the paper while holding it in your hands, you may drop the paper and cause it to curl up or fold.
Do not try to flick through too much paper at once.
6
Load the flicked paper into the paper tray.
in the upper-right of a page, it turns into 
and is registered as a bookmark.