Cleaning the SaddleStitcher SD-506
Overview
Clean the Conveyance belt of Bundle exit tray in the SaddleStitcher SD-506.
If the Conveyance belt is dirty, dirt may adhere to the output paper.
We recommend that you clean the tray each time you use it. Also, if Conveyance belt becomes dirty during use, clean it immediately.
Procedure
1
Pull out Bundle exit tray fully until it stops.
2
Stand under the tray.
NOTICE
- Be sure to set up the stand under the tray as it may cause the machine to malfunction.
3
Soak a soft cloth with cleaning alcohol, and wipe the visible parts of two Conveyance belt.
4
Move the Conveyance belt to clean the entire Conveyance belt.
Lightly lift two Conveyance belt with both hands, and at the same time pull them toward you to expose the uncleaned parts.
Wipe off the dirt on the Conveyance belt using a soft cloth soaked in cleaning alcohol.
You can clean the entire circumference of each belt by repeating steps 3 to 4 about 3 times.
NOTICE
- Do not lift the Conveyance belt more than necessary. Also, when pulling out the belts, pull out two belts at the same time. Pulling out only one of them may cause the machine to malfunction.
5
Clean the bottom of the Bundle exit tray.
Wipe the entire bottom surface with a soft cloth soaked in cleaning alcohol.
6
Return the stand to its original position and push the Bundle exit tray back into its original position.
Do not push the Bundle exit tray back into place with the stand upright.
in the upper-right of a page, it turns into 
and is registered as a bookmark.