Loading Paper Into the Paper Feeder Unit PF-602m
Overview
Load paper into the Paper Feeder Unit PF-602m.
Change the paper settings for the tray being used when loading paper of different specifications.
For details about the paper setting, refer to [Paper Setting].
NOTICE
- If the machine is not powered on, the tray cannot be pulled out. Turn the Sub power switch on. For details, refer to Turning This System On.
- Do not pull out multiple trays at once. Doing so may cause the machine to topple over.
Procedure
1
Pull out the paper replenishing tray.
Proceed to Step 2 when loading the paper of different sizes.
Proceed to Step 5 when loading paper of the same size.
2
Open out the Side guides and the Rear guide plate.
Rotate the Side guide lock knobs (4 locations) of the Side guides counterclockwise and loosen them.
Hold down the Side guide lock release lever of Side guides and the Rear edge guide lock release lever of Rear guide plate and open out the guides.
NOTICE
- When moving the Side guides, hold both the front side Side guide lock release lever and back side handles. Trying to move just with the front side Side guides may misalign the position of Side guides.
3
While holding down the Side guide lock release lever of Side guides, move the Side guides according to the Paper size indicator of the Tray bottom plate.
4
Rotate Side guide lock knobs (4 locations) of Side guides clockwise and lock them.
5
Load the paper with the print side facing up.
Load the paper so that it is aligned with the left side of the tray.
NOTICE
- Exercise care not to exceed the maximum stack height lines displayed on the tray Side guides when loading the paper.
- Small size guides are attached to two Side guides. Open these guides only when loading paper of width less than 182 mm / 7.17". For details about how to use the Small size guides, refer to Loading Small-sized Paper Into the Paper Feeder Unit PF-602m.
6
Align the Rear guide plate with the paper.
Hold down the Rear edge guide lock release lever of Rear guide plate and place against the paper.
NOTICE
- Make sure that Rear guide plate is placed firmly against the paper. If there is a gap between the Rear guide plate and the paper, the machine will not be able to properly detect the correct paper size, which may lead to a failure in the paper feeding device.
7
Firmly push the tray all the way in.
The remaining paper amount indicator changes from "
" to "
".
NOTICE
- Return the tray quietly. There may be an unexpected impact on the machine because of the weight of the tray or paper causing the malfunction.
in the upper-right of a page, it turns into 
and is registered as a bookmark.